serene – 2, part 38

any miscellaneous jobs required still to finish equipping my new kayak for upcoming paddling trips. First is adjusting the seat’s back rest, it’s a bit too high that strapping on the spray skirt could be a bit difficult. I simple cut down its back, then rivet the cut – out part onto the rest part. The hatches’ gaskets are cut from a thin (5 mm) rubber sheet (1st & 2nd images), should do their job of keeping the water out.

I made a new cart for transporting the boat on land, it’s just a smaller and lighter version of the previous one. I reused the pair of wheel, couldn’t reduce the wheels’ size since they have to be big enough so that the cart wouldn’t sink in when pulled on sand and mud. The result is quite satisfactory, big enough to easily transport the kayak, and small enough to not affect the boat stability when carried on the aft deck.

The list of small jobs to really finish the boat seems to be never ending, there’s always something I could do to improve, here and there, e.g: a mesh bag would be installed inside the cockpit, under the deck, to store various things I could need during a paddling trip, e.g: a small knife, a tiny light torch, a small monocular (to be equipped), reserved batteries for camera and GoPro, lighter, my tobacco box, etc…

It’s an interesting experience equipping a kayak for long paddling trips: everything need to be ready and accessible around your cockpit: food and drink, the back up paddle, the paddle float, radio and camera, everything… 😀 Fortunately, my newly purchased PFD has two pockets on the front side where I could hold some crucial things with me: the VHF radio, the Garmin and the Cannon waterproof small camera!

Leave a Reply